Document new --log-level switch

[infoex-autowx.git] / README.md

diff --git a/README.md b/README.md
index 520a72204b5bd27f41ff257c4127fdd519f38921..cda54b9a118d86ef34b4cfc0611209e3fe6df0d5 100644 (file)
--- a/README.md
+++ b/README.md
@@ -38,11 +38,16 @@ importation of data into your InfoEx subscriber account.
 To run ad-hoc (be sure to activate the virtual environment, as detailed in the
 Installation section):
 
-`./infoex-autowx.py --config [path/to/config-file.ini] [--dry-run]`
+`./infoex-autowx.py --config path/to/config-file.ini [--dry-run] [--log-level debug|info|warning]`
 
 **NOTE: Specifying --dry-run will also not clean up the generated CSV
 file.** This is so that you can debug any issues more easily.
 
+You can also specify `--log-level` as debug, info, warning. The
+resultant log messages will try to be logged to journald, but if that's
+not available, they will be printed to stdout. This output can be
+helpful early on in the setup process.
+
 Here's an example of a crontab(5) with two SNOTEL sites, each of which
 will run once per hour (note that this will activate the virtual environment
 created earlier):
@@ -194,14 +199,24 @@ with the data you see in your web browser.
 
 Here's the list of measurements currently supported:
 
-precipitationGauge
-tempPres
-hS
-baro
-rH
-windSpeedNum
-windDirectionNum
-windGustSpeedNum (only supported by MesoWest)
+**NRCS:**  
+PREC  
+TOBS  
+SNWD  
+PRES  
+RHUM  
+WSPD  
+WDIR  
+
+**MesoWest:**  
+precip\_accum  
+air\_temp  
+snow\_depth  
+pressure  
+relative\_humidity  
+wind\_speed  
+wind\_direction  
+wind\_gust  
 
 Future plans
 ------------